Introduction
We built this little heater for those moments when you need serious warmth in a seriously small package. Think of it—perfect for those display setups or hospitality spots where looks matter as much as heat. It runs on a 400V, 2500W halogen tube, which means you get that intense, direct radiant heat without any bulky, ugly hardware. It’s warm, it’s quick, and it actually looks good doing it.
The Inside Story
Here’s the neat part: that 400V, 2500W setup gives you a ton of heat while keeping the electrical draw surprisingly light. What that translates to for you? You can use thinner wiring and put less strain on your switches and contacts compared to a standard 230V unit of the same power. And the tube itself? Just 300mm long. So you can slip it into tight spots, tuck it into trim profiles, or slip it into existing enclosures without having to redesign everything from scratch.
What It’s Made Of
Inside, the halogen element lives in a quartz envelope. That’s there for a reason—it handles extreme heat like a champ and keeps the output steady. That halogen cycle inside is quietly working in the background, too. It helps keep the performance consistent over time by recycling the tungsten back onto the filament. No fuss. No gradual fade. And the R7s connector? It’s a simple, two-pin setup. Just wire it in, lock it down, and you’re good to go. Seriously, it’s a direct swap for most standard fixtures.
Where It Shines
If you’re an engineer trying to pack fast, radiant heat into a decorative fixture or a compact heating station, this is your kind of setup. You get a huge amount of heat density in a tiny footprint. But here’s the catch—with that kind of concentrated power, you do need to plan for proper cooling and spacing. Give it some breathing room, keep surface temps in check, and make sure nearby materials stay well within the safe zone.